Features:

• Fast and effortless resin injection
• Convenient dispensing tool for a range of situations
• Type of gun used for anchoring strictly depends on the type of cartridge
• Robust design for all job site conditions

Applications

• Dosing of bonded resins and other mediums from coaxial 380 -410 ml cartridges.
• Manual operation - no need for external power supply
• For use in a wide range of fastening applications in concrete and solid masonry structures

Installation Guide

1. Prepare the gun. Unlock the squeezer with the push button and pull it backwards.
2. Place the cartridge with the attached mixer in the guide.
3. The squeeze dispensing unit is equipped for continuous or programmed dosing - selectable via the MANUAL / REPEAT push button.
4. Dose the desired amount of resin. In continuous mode "MANUAL", the extrusion speed is controlled by the knob. In repeat dose mode "REPEAT", the dose rate is set by: setting the slide button to "MANUAL" mode, pressing down the desired quantity, releasing the trigger and moving the button to the "REPEAT" mode. Dose programming must take place after obtaining a uniform colour of the mixture through the nozzle. Dosing of the already memorised dose is done by pressing and holding the trigger. The squeezer stops after squeezing the dose. Release the trigger.
5. When finished, pull the stem and remove the cartridge. Clean contaminated parts of the dispenser if necessary.
6. When using, be sure to follow safety warnings in accordance with the Material Safety Data Sheet.